|
|
|
|
|
Specifications |
|
|
|
Use |
General laboratory liquid-liquid mixing &
emulsification |
|
|
Mixing head
configuration |
Standard:
1mm rotor nozzles
Options: 0.5 - 2.5mm nozzles (sizes drilled
to order) |
|
|
Construction materials |
Wetted
parts - 300 series stainless steel standard (other
materials such as titanium and Hastelloy are
available on request)
Bearings - polymer thrust and radial bearings.
Note that the mixer must NOT be run dry.
Base - stainless steel baseplate |
|
|
Shaft
seal |
Single mechanical component seal above
the mixing head |
|
|
Electrical supply |
110V or 220-240V, 50/60Hz, single
phase supply to controller |
|
|
Controls (optional) |
- Mains
on/off
- Start / stop pushbuttons
- Speed & load displays
- Speed control potentiometer |
|
|
Other options |
ATEX-compliant - a wide
range of EExd motors is available.
Hygienic - to meet the requirements of cGMP
and other standards |
|
