|
|
|
|
|
Specifications |
|
|
|
Use |
General pilot-scale or full
production-scale high shear mixing |
|
|
Mixing head
configuration |
Standard:
2/3
(2 cavity rows on stator,
3 on rotor)
Options: 3/4 and 4/4 heads available |
|
|
Construction materials |
Wetted
parts - 300 series stainless steel standard (other
materials such as titanium, Hastelloy and ceramics are
available on request)
Bearings - lower polymer bush (FDA-approved
material) upper rolling element bearings standard.
Note that the standard mixer must NOT be run dry.
Mountings - stainless steel or painted structural
steel as required |
|
|
Electrical supply |
380-420V, 50/60Hz,
3-phase - other options on request |
|
|
Options |
High
Flow - a removable half-height or full-height
impeller can be fitted to the back of the rotor to act
as an additional agitator in the vessel. This can
multiply general flow by more than 10 times if a high
degree of agitation is needed.
ATEX-compliant - a wide
range of EExd motors is available.
Hygienic - to meet the requirements of cGMP
and other standards |
|
